The Series SW-218 Switches are Broadband, High Speed, Low Loss SPST Switches
With Integral Drivers.  They are Powered by +5 and -15 Volt Supplies and are
Available Powered by ±15 Volts.  They are Available in Three Models that Operate
Over the Entire 0.5 to 18 GHz Band.  Each Features Rugged Integrated Circuit
Assemblies of Chip PIN on a Microstrip Transmission Line and Proprietary Wideband
Bias Decoupling Circuitry.  Switching is Accomplished by a TTL Compatible Driver
Which is Controlled by the User.

Specifications:

Frequency Range	0.5 - 18 GHz
Isolation	30 dB Minimum
Insertion Loss	2.0 dB Maximum
VSWR (On Position)	1.9:1 Maximum
Switching Speed	(10% - 90% RF) and (90% - 10% RF): 10 ns
TTL Delay	From 50% TTL to 90% RF for Turn-Off: 20 ns From 50% TTL to 10% RF for Turn-On: 20 ns
Power Handling Capability	Average: 2 Watts Peak 1 usec, Maximum, pw: 10 Watts
Power Supply	+15 VDC: 100 mA +  5 VDC: 100 mA - 15 VDC: 45 mA
Control Impedance	TTL Compatible, Two Load. (A Load is 1.6 mA Sink Current and 40 uA Source Current.)
Control Logic	Logic "0" (-0.3 to +0.7 Volt) for Switch Off. Logic "1" (+2.5 to +5.0 Volts) for Switch On.

Available Options:
 

001	Two SMA Male RF Connectors
002	One SMA Male and One SMA Female RF Connector
003	Solder Type Control Terminals
004	±15 Volt Power Supply Requirement (+5, -15 Volt is Standard)
005	50 Ohm Control Impedance
006	Cannon MultiPin MDM9SSP
007	Inverted Logic
008	Extend Frequency to 100 MHz
010	50 ns Maximum Switching Speed (5 Watts CW Maximum)
012	2 ns Maximum Switching Speed (100 mw CW Maximum)
013	-12 VDC Power Supply Requirement
103	Integral Video Filters (2-18 GHz Frequency Band)

Environmental Ratings:

Outline Drawing:

Click here to see the Outline Drawing for SW-2182-1A

Product Feature:

Click here to see the Product Feature for SW-2182-1A